LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2017 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Windows >> Doors - 453 Chassis >> Testing & Repair >> Remove/Install Front Door Panel - AR72.10-P-6575SRA

Remove/Install Front Door Panel - AR72.10-P-6575SRA

MODEL 453.3/4 

Shown on Model 453.3 with code V21 

(Electrically adjustable heated outside mirror (FFO)), on left side of the vehicle 

G12096257

Shown on left door trim  (1)

G12096258
  Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Switch off ignition and remove key    
2 Remove door paneling   AR72.18-P-1000SRA 
3 Disconnect left front electrical connector (X35/1) or right front door electrical connector (X35/2)    
4 Disconnect electrical connection (10)    
5 Disconnect electrical connection (11)    
6 Remove grommet (21) and pull electrical wiring harness (26) in direction of door paneling (1)    
7.1 Unclip cap in door handle with suitable tool and unscrew bolt (3) behind Model 453.3/4
except code V21 (Electrically adjustable and heated outside mirrors (FFO))
 
7.2 Remove outside mirror adjustment switch (S50), disconnect electrical connector and unscrew bolt (3) behind Model 453.3/4
with code V21 (Electrically adjustable and heated outside mirrors (FFO))
When removing door panel (1) on drive side.
 
8 Unclip cap (4)    
9 Remove screw (5)    
10 Unscrew screw/bolt (7)    
11 Remove expansion rivet (9)    
12 Unclip door panel (1) starting at bottom and lift upward until electrical connectors and wire on inside door opener are accessible SPECIAL TOOL Mounting wedge Fig 1
13 Disconnect electrical connectors and wire from inside door opener IMPORTANT The number of electrical connectors varies according to vehicle equipment.  
14 Remove door trim (1) INSTALLATION IMPORTANT : Ensure that the retaining tabs (13) are correctly positioned in the inner sealing rail (15).  
15 Check the retaining clips (12) for damage If complaint present

Replace retaining clips (12)
 
16 Unclip inside door opener from door trim (1) When replacing door trim (1).  
17 Remove left front speaker (H4/5) or right front speaker (H4/6) from door trim (1) When replacing door trim (1).  
18 Remove driver side power window switch
(S20/1) or passenger side power window switch
(S21/2) from door trim (1)
When replacing door trim (1).  
19 Remove electrical subharness (26) from door trim (1) When replacing door trim (1).  
20 Install in the reverse order    
Fig 1: Identifying Mounting Wedge (110 589 03 59 00)
G11128970