Remove/install flywheel/drive plate - AR03.30-P-8001CMG
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 156 in MODEL 204, 212
| Remove/install | |||
| 1 | Remove transmission | MODEL 204 | AR27.10-P-0500CV |
| MODEL 212 | AR27.10-P-0500EV | ||
| 2 | Mark the Flex plate (2) | ||
| 3 | Counterhold crankshaft with counterholder | Figure | |
| 4 | Remove screw/bolts (3) from driven plate (1) | Replace screw/bolts (3). The connection will loosen otherwise or the screw/bolt (3) will tear off. |
|
| *BA03.30-P-1002-01Q | |||
| 5 | Remove flex plate (2) | The flex plate (2) must be mounted again in the same position. The ridges arising change the torque otherwise. |
|
| 6 | Remove driven plate (1) | ||
| Check | |||
| 7 | Check threaded unions in the driven plate (1) | If threaded unions are damaged or loose: ↓ The driven plate (1) must be replaced. |
|
| 8 | Install in the reverse order | ||
| 9 | Carry out initialization with Star Diagnosis | When replacing the driven plate (1) | |
| AD00.00-P-2000-04A | |||
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | ENGINE 156 | ||
|---|---|---|---|---|
| BA03.30-P-1002-01Q | Screw/bolt, starter ring gear/drive plate to crankshaft | Stage 1 | Nm | 20 |
| Stage 2 | Nm | 45 | ||
| Stage 3 | ∠° | 90 | ||