Remove/install vacuum pump - AR43.05-P-1320ELB
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 207 with ENGINE 278
MODEL 212, 218 with ENGINE 157, 278
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Drain coolant | MODEL 207 with ENGINE 278 | AR20.00-P-1142FH |
| MODEL 212, 218 with ENGINE 157, 278 | AR20.00-P-1142EL | ||
| 2 | Remove engine cover | ||
| 3 | Remove left-hand air filter housing | ||
| 4 | Remove insulation on left rail | ||
| 5 | Disconnect engine wiring harness from ME-SFI control unit (N3/10) and rear intake manifold | AR01.00-P-2410-02ELB | |
| 6 | Unclip engine wiring harness from intake manifold and place to one side | ||
| 7 | Disconnect vacuum line (2) from vacuum pump (1), intake manifold and connecting point on bulkhead and remove | ||
| 8 | Detach vacuum hose (4) from vacuum pump (1) | ||
| 9 | Detach coolant line to heat exchanger on bulkhead and set aside | ||
| 10 | Remove bolts (3) from vacuum pump (1) | ||
| *BA43.05-P-1001-01K | |||
| 11 | Remove vacuum pump (1) upwards | ||
| 12 | Install in the reverse order | ||
| 13 | Check coolant level and cooling system for leaks | MODEL 207 with ENGINE 278 | AR20.00-P-1010FH |
| MODEL 212, 218 with ENGINE 157, 278 | AR20.00-P-1010EL | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 14 | Test run engine and carry out leak check |
VACUUM PUMP
| Number | Designation | MODEL 166, 212, 216, 218, 221, 231 with ENGINE 157 | MODEL 166, 207, 212, 216, 218, 221, 231 with ENGINE 278 | |
|---|---|---|---|---|
| BA43.05-P-1001-01K | Bolt, vacuum pump to cylinder head/cylinder head cover | Nm | 9 | 9 |