Remove/install additional fan for COMAND - AR82.85-P-0005ELA

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 207 as of 6/1/13 as of model year 2014 with CODE 512 (COMAND APS with DVD changer)

MODEL 207 as of 6/1/13 as of model year 2014 with CODE 527 (COMAND APS with single DVD drive (with navigation))

MODEL 212 as of 4/14/13 as of model year 2014 with CODE 512 (COMAND APS with DVD changer)

MODEL 212 as of 4/14/13 as of model year 2014 with CODE 527 (COMAND APS with single DVD drive (with navigation))

MODEL 218 as of 3/1/13 as of model year 2014 with CODE 512 (COMAND APS with DVD changer)

MODEL 218 as of 3/1/13 as of model year 2014 with CODE 527 (COMAND APS with single DVD drive (with navigation))

MODEL 218 as of 3/1/13 as of model year 2014 with CODE 528 (COMAND with DVD changer)

MODEL 218 as of 3/1/13 as of model year 2014 with CODE 531 (COMAND APS)

Illustrated on model 207

Fig 1: COMAND Fan Motor Remove/Install Components - Shown On Model 207

Courtesy of MERCEDES-BENZ USA

Illustrated on model 207

Fig 2: COMAND Fan Motor Remove/Install Components - Shown On Model 207

Courtesy of MERCEDES-BENZ USA

	Remove/install
1.1	Switch off ignition and remove transmitter key from electronic ignition lock control unit	MODEL 207, 212, 218 except CODE 889 (KEYLESS-GO)
1.2	Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit	MODEL 207, 212, 218 with CODE 889 (KEYLESS-GO)
2	Remove glove compartment	MODEL 207	AR68.10-P-1400EC
		MODEL 212	AR68.10-P-1200EW
		MODEL 218	AR68.10-P-1400EL
3	Remove screw/bolts (6)	Prevent screws (6) from falling.
4	Remove COMAND fan motor (M4/13) from air duct (1)
5	Disconnect electrical connector of electrical wiring harness (4) at COMAND fan motor (M4/13)
6	Remove air filter (3) from COMAND fan motor (M4/13)	When replacing COMAND fan motor (M4/13).
7	Install in the reverse order