LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2015 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Suspension - 451 Chassis >> Testing & Repair >> Remove/install front engine mount >> Remove/install front engine mount - AR22.10-P-4330MEX

Remove/install front engine mount - AR22.10-P-4330MEX

ENGINE 780.993 in MODEL 451.390/392/490/492 

Fig 1: Identifying Front Engine Mount Remove/Install Components
G10978252DANGERNOTESNOTESNOTESREMOVINGINSTALLINGREFER TO SPECIAL TOOLSNOTESTORQUE SPECIFICATIONTORQUE SPECIFICATIONCourtesy of MERCEDES-BENZ USA
DANGER Risk of death  when touching components on vehicles with high-voltage on-board electrical system Do not touch components and open lines of the high-voltage on-board electrical system. Persons who wear electronic implants (e.g. cardiac pacemakers), must not  carry out any work on high-voltage on-board electrical systems. AS54.00-Z-0001-01A
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
NOTES Note on high-voltage battery   AH54.10-P-0006-01MEV
NOTES Note on high-voltage on-board electrical system   AH54.00-P-0010-01A
REMOVINGINSTALLING Remove/install     
1 Remove transmitter key and battery charger power supply plug    
2 Raise vehicle using the vehicle lift and secure in place When work is continued on the vehicle such as, e.g. when supporting major assemblies using a jack (e.g. telescopic lifter) which exert an uneven load distribution, and when removing the following components: front axle, front axle carrier, axle tube, rear axle integral carrier, engine or transmission. AR00.60-P-0100MCC
3 Support transmission using the telescopic lifter and removal fixture    
REFER TO SPECIAL TOOLS 000 588 11 62 00 Major assembly mount NOTES
The transmission must not be raised under any circumstances.
The engine stabilizer mount (1) will be stretched by this during installation and thus pre-damaged otherwise.
WS01.00-P-0092B
4 Unscrew screw/bolt (2) TORQUE SPECIFICATION Screw/bolt, torque support to front engine mount carrier *BA22.10-P-1011-01M 
5 Counterhold nuts (4) and remove screw/bolt (3) TORQUE SPECIFICATION Screw/bolt, torque support to integral carrier *BA22.10-P-1010-01M 
6 Remove engine stabilizer mount (1)    
7 Install in the reverse order    
ENGINE MOUNTS, ENGINE SUPPORTS

Number Designation ENGINE 780.993
BA22.10-P-1010-01M Screw/bolt, torque support to integral carrier Nm 115
ENGINE MOUNTS, ENGINE SUPPORTS

Number Designation ENGINE 780.993
BA22.10-P-1011-01M Screw/bolt, torque support to front engine mount carrier Nm 115