Remove/install front engine mount - AR22.10-P-4330MCC

ENGINE 132.9 in MODEL 451.3/4 

ENGINE 780.009 in MODEL 451.391/491 

Shown on vehicle with engine 132.9 

Fig 1: Identifying Front Engine Mount Remove/Install Components - Shown On Vehicle With Engine 132.9

Courtesy of MERCEDES-BENZ USA

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of death  when touching components on vehicles with high-voltage on-board electrical system	Do not touch components and open lines of the high-voltage on-board electrical system. Persons who wear electronic implants (e.g. cardiac pacemakers), must not  carry out any work on high-voltage on-board electrical systems.	AS54.00-Z-0001-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Note on high-voltage battery		AH54.10-P-0006-01MEV
	Note on high-voltage on-board electrical system		AH54.00-P-0010-01A
	Remove/install
1	Raise vehicle with vehicle lift
2	Support transmission with telescopic lifter and removal fixture
	000 588 11 62 00 Major assembly mount	The transmission must not be raised under any circumstances. The engine stabilizer mount (1) would be under stress by this during installation and thus pre-damaged.	WS01.00-P-0092B
3	Remove screw/bolt (2)	Screw/bolt, torque support to front engine mount carrier	*BA22.10-P-1011-01M
4	Counterhold nuts (4) and remove screw/bolt (3)	Screw/bolt, torque support to integral carrier	*BA22.10-P-1010-01M
5	Remove engine stabilizer mount (1)
6	Install in the reverse order