LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2015 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication, Engine Oil Cooling - 451 Chassis >> Testing & Repair >> Check oil pressure - AR18.00-P-1250MCU

Check oil pressure - AR18.00-P-1250MCU

ENGINES 132.910 in MODEL 451.3/4 

Fig 1: Identifying Oil Pressure Switch
G10978149Courtesy of MERCEDES-BENZ USA
REMOVING Removing     
DANGER Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the engine as it is running Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.
AS00.00-Z-0005-01A
1 Remove oil pressure switch (S41/1)   AR18.40-P-4132MCU 
INSPECT Checking     
2 Screw adapter into threaded hole for oil pressure switch (S41/1) SPECIAL TOOL Oil pressure tester Fig 2
3 Attach oil pressure testing device to adapter SPECIAL TOOL Oil pressure tester Fig 2
4 Lower vehicle with vehicle lift    
5 Remove interior flap above engine   AR88.40-P-1100-03MCC
6 Check engine oil level, correct if necessary    
REFER TO CAPACITIES & SPECIFICATIONS Multigrade engine oils (Sheet 229.5) Sheet 229.5 Multigrade engine oils (specification 229.5). See https://bevo.mercedes-benz.com/index.php?language_id=1
7 Allow engine to run until operating temperature of about 80°C has been reached and read off the engine oil pressure for idle speed on the oil pressure testing device pressure gauge Oil pressure tester   *BE18.00-P-1002-01E 
    SPECIAL TOOL Fig 2
8 Increase the engine speed to 3500 rpm and read off the pressure on the gauge of the oil pressure tester with the engine warm.   *BE18.00-P-1003-01E 
    SPECIAL TOOL Oil pressure tester Fig 2
9 Turn off engine    
10 Raise vehicle with vehicle lift    
11 Detach on oil pressure testing device from adapter and remove adapter from threaded hole for oil pressure switch (S41/1)    
INSTALLING Install     
12 Install oil pressure switch (S41/1)   AR18.40-P-4132MCU 
13 Lower vehicle with vehicle lift    
14 Install interior flap above engine   AR88.40-P-1100-03MCC
OIL PRESSURE TEST SPECIFICATIONS

Number Designation Engine 132
BE18.00-P-1002-01E Oil pressure engine at operating temperature and idling bar 0.6 to 1.6
BE18.00-P-1003-01E Oil pressure at engine operating temperature and 3500 rpm bar 2.5 to 4.3
Fig 2: Identifying Oil Pressure Tester (450 589 13 21 00)
G10978150Courtesy of MERCEDES-BENZ USA