Retrofit trim - AZ68.30-P-0006MCC

MODEL 451.3/4 except CODE (P02) car2go 

Trim parts 

Fig 1: Identifying Trim Related Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Trim Related Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove
1	Unclip left front door panel cover (1) and right front door panel cover (2) from front area of door panel (7) with assembly wedge (8)	First loosen left front door panel cover (1) and right front door panel cover (2) in lower area with assembly wedge (8) as shown.
		Assembly wedge	Figure
2	Push left front door panel cover (1) and right front door panel cover (2) toward front and guide out of door paneling (7) in rear area (arrow A).
3	Remove selector lever cover (3)	* not for USA	AR68.20-P-2309MCC
		* for USA only	AR68.20-P-2309MCU
4	Loosen combination switch caps (4) from combination switch (S4) with suitable knife and remove	Ensure that combination switch (S4) is not damaged.
5	Unclip combination switch cover (5) from instrument cluster with assembly wedge (8) and remove.	Assembly wedge	Figure
6	Unclip additional instrument covers (6) from cockpit clock and tachometer with assembly wedge (8) and remove	With code (V31) Cockpit clock and tachometer package
		Assembly wedge	Figure
7	Install in the reverse order	Replace corresponding trim parts with new trim parts
8	Clean installed trim parts with cleaning agent approved by Daimler AG

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA