Retrofit BRABUS additional headlamps - AN82.10-P-0007MCC

MODEL 451.3 (except 451.391) up to 3/19/12, 451.4 (except 451.491) up to 3/19/12 

with CODE V07 (Front fog lamps (FFO)) 

except CODE 460 (Canada version) 

Fig 1: Identifying Left And Right Additional Headlamp

Courtesy of MERCEDES-BENZ USA

	Remove
1	Disconnect battery ground line
			AR54.10-P-0003MCC
2	Remove front CBS
			AR88.00-P-1010MCC
3	Remove left front headlamp unit	* not for USA ↓
			AR82.10-P-4730MCC
		*for USA only ↓
			AR82.10-P-4730MCU
4	Remove left front fog lamp and right front fog lamp	* not for USA ↓
			AR82.10-P-5103MCC
		* for USA only ↓
			AR82.10-P-5103MCU
5	Unclip covers of left front fog lamp and right front fog lamp from CBS front section and remove
	Install
6	Retrofit wiring harness for right additional headlamp (1) and left additional headlamp (2)		AN82.10-P-0007-01MCC
		Ensure that the wiring harnesses cannot be damaged by chafing or pinching. Consequential damage can occur otherwise. Wiring harness repair kit, basic	Fig 2
7	Retrofit right additional headlamp (1) and left additional headlamp (2)		AN82.10-P-0007-02MCC
8	Connect ground cable to battery
			AR54.10-P-0003MCC
9	Install left front lamp unit	* not for USA ↓
			AR82.10-P-4730MCC
		* for USA only ↓
			AR82.10-P-4730MCU
10	Install new covers for right additional headlamp (1) and left additional headlamp (2) into CBS front section
11	Install front CBS
			AR88.00-P-1010MCC
12	Switch on ignition and run function test of right additional headlamp (1) and left additional headlamp (2)
13	Adjust front fog lamps and daytime running lamps
			AP82.10-P-8260MCC

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA