Retrofit additional instruments - AZ54.30-P-0001MCD
MODEL 451.3/4 as of 31.8.10
Parts scope for additional instrument (A15)
| Remove | |||
| 1 | Adjust driver seat to the rear | ||
| 2 | Remove instrument cluster (A1) | * not for USA | AR54.30-P-6015MCC |
| * for USA only | AR54.30-P-6015MCU | ||
| 3 | Detach covering (3) with clip remover, as shown, and remove | *452589016300 | |
| Install | |||
| 4 | Slide wiring harness for additional instruments (6) through the left opening and under the covering (3) towards the instrument cluster | ||
| 5 | Clip additional instruments (A15) into instrument panel | ||
| 6 | Bend into the footwell and route wiring harness for additional instrument (6) at the bottom of the instrument panel upper section towards the instrument cluster | ||
| 7 | Hook wiring harness for additional instruments (6) into holders (arrow C and B) at bottom on instrument panel upper section | ||
| 8 | Detach black, 3-pin connector (5) from vehicle wiring harness in area of instrument cluster (A1) | ||
| 9 | Connect black, 3-pin connector (5) and black, 3-pin coupling (6.1) of wiring harness for additional instruments (6) | ||
| 10 | Use bolt (1) to tighten additional instruments (A15) | ||
| 11 | Clip cover (2) over the bolt (1) on the additional instruments (A15) | ||
| 12 | Move driver seat back to its default position | ||
| 13 | Install in the reverse order | ||
| 14 | Set clock of additional instruments (A15) | ||
| 15 | Connect Star Diagnosis | AD00.00-P-2000-04MCC | |
| 16 | Enter special equipment on the vehicle data card and the online vehicle data card | ||
| 17 | Disconnect Star Diagnosis | AD00.00-P-2000-04MCC | |
| 18 | Document retrofitted equipment using vehicle documentation (VeDoc) |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| DG 54 (see EPC) | Additional instruments | 1 |
| DG 54 (see EPC) | Screw | 1 |
| DG 54 (see EPC) | Cover | 1 |