Connect STAR DIAGNOSIS and read out fault memory - AD00.00-P-2000-04MCC

Fig 1: Identifying Data Link Connector Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Release flap (1) in upper area (arrow) and fold downward.
Connect STAR DIAGNOSIS to data link connector (X11/4).
Ensure that STAR DIAGNOSIS (2) plug locks in position.
Switch on ignition.
Start DAS application.
Stored faults which may be caused by disconnecting cables or by simulation during testing operations must be deleted in the diagnostic trouble code memory following the completion of the operations.
Disconnect STAR DIAGNOSIS in reverse order.