Installation [07/2015 - ]: Procedure

INSTALL COMBINATION METER

NOTE:

If the combination meter is left for a long time with its screen facing down, grease applied to the needles may spill and the needles may not operate smoothly. When storing the combination meter, store it with its screen facing upward.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Screen Facing Up
*b	Good
*c	Screen Facing Down
*d	No Good
*e	Screen

HINT:

If configuration cannot be performed by reading/writing of the vehicle specification information, perform the configuration using As-Built information after replacing the combination meter.

See step 3

Connect the connector.
Install the combination meter.
Install the screws.
Install the meter hood.
Refer to INSTALLATION [07/2015 - ]
Remove the upper column cover.
Refer to PROCEDURE - Step 1
Connect the negative battery cable.
Refer to PROCEDURE - Step 1
When replacing the combination meter, perform the configuration.
See step 2