Combination Meter: Installation: Installation

INSTALL COMBINATION METER ASSEMBLY

Fig 1: Locating Wire Harness Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Connect the 2 connectors.
2. Install the wire harness.
3. Install the combination meter with 4 screws.
  
  Fig 2: Locating Combination Meter Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY . Refer to INSTALLATION - Step 16
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)