Front Wiper Motor: Removal

1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 windshield wiper arm covers.
   Fig 1: Removing Windshield Wiper Arm Cover

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
2. Remove the nut and front wiper arm.

Fig 2: Locating Front Wiper Arm Nut

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure as for the LH side.

1. Disengage the 5 clips and remove the hood to cowl top seal.
   Fig 3: Identifying Cowl Top Seal Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the clip.
2. Disengage the 6 claws and remove the cowl top ventilator louver.
   Fig 4: Identifying Cowl Top Ventilator Louver Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the clip.
2. Disengage the 2 claws and remove the cowl top ventilator louver.
   Fig 5: Identifying Cowl Top Ventilator Louver Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 bolts.
2. Slide the wiper link. Disengage the link from the rubber pin, then disconnect the connector and remove the front wiper motor and link.
   Fig 6: Locating Front Wiper Motor And Link Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a screwdriver with its tip wrapped in protective tape, pry the second rod off the crank arm pivot of the front wiper motor.
   Fig 7: Prying Second Rod Off Crank Arm Pivot Of Front Wiper Motor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver with its tip wrapped in protective tape, pry the first rod off the crank arm pivot of the front wiper motor.
   Fig 8: Prying First Rod Off Crank Arm Pivot Of Front Wiper Motor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a "TORX" socket wrench T30, remove the 2 screws, and the front wiper motor.
   Fig 9: Locating Front Wiper Motor Screws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002