Inspection Procedure

HINT:

If DTC U0100 has been stored, troubleshoot the CAN communication system first.

1. CONFIRM DTC OUTPUT (ECM) 
   1. Check DTCs (See DTC CHECK/CLEAR ).

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC P0335 is not output	A
      DTC P0335 is output	B

   B: Go TO DTC P0335  (See DTC P0335 CRANKSHAFT POSITION SENSOR "A" CIRCUIT; DTC P0339 CRANKSHAFT POSITION SENSOR "A" CIRCUIT INTERMITTENT )

   A: Go to next step 

2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER OR TECHSTREAM (TACHOMETER) 
   1. Connect an intelligent tester or a Techstream to the DLC3.
   2. Turn the ignition switch on (IG) and turn the tester on.
   3. Operate the intelligent tester or Techstream according to the display and select "ACTIVE TEST" or "Active Test" (See DATA LIST / ACTIVE TEST  ).
      1. Intelligent tester

         Body / Combination Meter / ACTIVE TEST: 

         BODY / COMBINATION METER / ACTIVE TEST
         
         

         Item	Test Details	Diagnostic Note
         TACHOMETER	0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm	Value selected during ACTIVE TEST is displayed

      2. Techstream

         Body Electrical / Combination meter / Active Test: 

         BODY ELECTRICAL / COMBINATION METER / ACTIVE TEST
         
         

         Item	Test Details	Diagnostic Note
         Tachometer Operation	0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm	Value selected during Active Test is displayed

         OK: 

         Engine speed displayed on the tester is approximately the same as that of the tachometer reading. 

   NG : REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL  )

   OK: Go to next step 

3. READ VALUE USING INTELLIGENT TESTER OR TECHSTREAM (TACHOMETER) 
   1. Connect an intelligent tester or a Techstream to the DLC3.
   2. Engine start and turn the tester on.
   3. Operate the intelligent tester or Techstream according to the display and select "DATA LIST" or "Data List" (See DATA LIST / ACTIVE TEST  ).
      1. Intelligent tester

         Body / Combination Meter / DATA LIST: 

         BODY / COMBINATION METER / DATA LIST
         
         

         Item	Measurement Item / Range	Normal Condition	Diagnostic Note
         TACHOMETER	Engine speed Min.: 0 Max.: 12,750	Approximately same as actual engine speed (When engine is running)	Unit: rpm

      2. Techstream

         Body Electrical / Combination Meter / Data List: 

         BODY ELECTRICAL / COMBINATION METER / DATA LIST
         
         

         Item	Measurement Item / Range	Normal Condition	Diagnostic Note
         Engine RPM	Engine speed Min.: 0 Max.: 12,750	Approximately same as actual engine speed (When engine is running)	Unit: rpm

         OK: 

         Engine speed displayed on the tester is approximately the same as that displayed on the combination meter. 

         NOTE: Determine whether the value displayed on the tester is within the acceptable range by referring to reference values described in "ON-VEHICLE INSPECTION " .

   NG : REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL  )

   OK : USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )