Inspection Procedure

HINT:

These codes are detected when a problem is detected in the brake actuator assy. The ABS solenoid circuit is in the brake actuator assy. Therefore, solenoid circuit inspection and relay unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the brake actuator assy.

1. Clear the DTCs (see DTC CHECK/CLEAR  ).
2. Turn the ignition switch ON.
3. Check if the same DTCs are recorded (see DTC CHECK/CLEAR  ).

1. NG : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON  PROBLEM SYMPTOMS TABLE   ) 
2. OK : REPLACE BRAKE ACTUATOR ASSY (See  REPLACEMENT  )