LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2004 >> xB Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs With EBD & BA & TRAC & VSC System - Diagnosis >> Problem Symptoms Table

Problem Symptoms Table

DTC INDEX

DTC Description
DTC C0200/31, C0205/32, C1235/35, C1236/36  RIGHT FRONT SPEED SENSOR, LEFT FRONT SPEED SENSOR CIRCUIT, FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR
DTC C0210/33, C0215/34, C1238/38, C1239/39  RIGHT REAR SPEED SENSOR, LEFT REAR SPEED SENSOR CIRCUIT, FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT REAR SENSOR, FOREIGN MATTER IS ATTACHED ON TIP OF LEFT REAR SENSOR
DTC C0226/21, C0236/22, C0246/23, C0256/24, C1225/25  SFR SOLENOID CIRCUIT, SFL SOLENOID CIRCUIT, SRR SOLENOID CIRCUIT, SRL SOLENOID CIRCUIT, SMC SOLENOID CIRCUIT
DTC C0273/13, C0274/14, C1361/91  OPEN OR SHORT CIRCUIT IN ABS MOTOR RELAY CIRCUIT, SHORT CIRCUIT IN ABS MOTOR RELAY CIRCUIT, SHORT CIRCUIT IN ABS MOTOR FAIL SAFE RELAY CIRCUIT
DTC C0278/11, C0279/12  OPEN CIRCUIT IN ABS SOLENOID RELAY CIRCUIT, SHORT CIRCUIT IN ABS SOLENOID RELAY CIRCUIT
DTC C1201/51  ENGINE CONTROL SYSTEM MALFUNCTION
DTC C1203/53  ECM COMMUNICATION CIRCUIT MALFUNCTION
DTC C1210/36, C1336/39  ZERO POINT CALIBRATION OF YAW RATE SENSOR UNDONE, ZERO POINT CALIBRATION OF DECELERATION SENSOR UNDONE
DTC C1223/43  ABS CONTROL SYSTEM MALFUNCTION
DTC C1224/44  NE SIGNAL CIRCUIT
DTC C1231/31  MALFUNCTION IN STEERING ANGLE SENSOR CIRCUIT
DTC C1232/32, C1234/34, C1243/43, C1244/44, C1245/45, C1381/97  MALFUNCTION IN DECELERATION SENSOR, MALFUNCTION IN YAW RATE SENSOR, MALFUNCTION IN DECELERATION SENSOR, OPEN OR SHORT IN DECELERATION SENSOR CIRCUIT, MALFUNCTION IN DECELERATION SENSOR, MALFUNCTION IN POWER SUPPLY VOLTAGE YAW/DECELERATION SENSOR
DTC C1241/41  LOW BATTERY POSITIVE VOLTAGE
DTC C1246/46  MALFUNCTION IN MASTER CYLINDER PRESSURE SENSOR
DTC C1249/49  OPEN CIRCUIT IN STOP LIGHT SWITCH CIRCUIT
DTC C1251/51  PUMP MOTOR IS LOCKED/OPEN CIRCUIT IN PUMP MOTOR GROUND

If a normal code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTE:
  • When replacing the skid control ECU, sensors or etc., turn the ignition switch off. 
  • When replacing yaw rate sensor and/or the brake actuator assy, make sure to perform yaw rate sensor zero point calibration (See  CALIBRATION   ). 
PROBLEM SYMPTOMS

Symptom Suspect Area Go To
ABS does not operate
BA does not operate
EBD does not operate		 If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. IG power source circuit and ground circuit
  3. Speed sensor circuit
  4. Check the ABS & Traction actuator with a hand-held tester.

If abnormal, check the hydraulic circuit for leakage.
  1. DTC CHECK/CLEAR 
  2. DTC C1241/41 LOW BATTERY POSITIVE VOLTAGE 
  3. DTC C0200/31 RIGHT FRONT SPEED SENSOR DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR  and DTC C0210/33 RIGHT REAR SPEED SENSOR DTC C0215/34 LEFT REAR SPEED SENSOR CIRCUIT DTC C1238/38 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT REAR SENSOR DTC C1239/39 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT REAR SENSOR 
  4. DTC CHECK/CLEAR 
ABS does not operate efficiently
BA does not operate efficiently
EBD does not operate efficiently		 If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. IG power source circuit and ground circuit
  3. Speed sensor circuit
  4. Stop light switch circuit
  5. Check the ABS & Traction actuator with a hand-held tester.

If abnormal, check the hydraulic circuit for leakage.
  1. DTC CHECK/CLEAR 
  2. DTC C1241/41 LOW BATTERY POSITIVE VOLTAGE 
  3. DTC C0200/31 RIGHT FRONT SPEED SENSOR DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR  and DTC C0210/33 RIGHT REAR SPEED SENSOR DTC C0215/34 LEFT REAR SPEED SENSOR CIRCUIT DTC C1238/38 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT REAR SENSOR DTC C1239/39 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT REAR SENSOR 
  4. DTC C1249/49 OPEN CIRCUIT IN STOP LIGHT SWITCH CIRCUIT 
  5. DTC CHECK/CLEAR 
ABS warning light abnormal
  1. ABS warning light circuit
  2. Skid control ECU
 ABS WARNING LIGHT CIRCUIT (REMAINS ON) 
DTC of ABS check cannot be done If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. Tc terminal circuit
  1. DTC CHECK/CLEAR 
  2. TC TERMINAL CIRCUIT 
Sensor signal check cannot be done
  1. Skid control ECU
  
VSC does not operate
TRAC does not operate		 If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. IG power source circuit
  3. Check the hydraulic circuit for leakage.
  4. Speed sensor circuit
  5. Deceleration sensor circuit
  6. Yaw rate sensor circuit
  7. Steering sensor circuit
  1. DTC CHECK/CLEAR 
  2. DTC C1241/41 LOW BATTERY POSITIVE VOLTAGE 
  3. -
  4. DTC C0200/31 RIGHT FRONT SPEED SENSOR DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR  and DTC C0210/33 RIGHT REAR SPEED SENSOR DTC C0215/34 LEFT REAR SPEED SENSOR CIRCUIT DTC C1238/38 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT REAR SENSOR DTC C1239/39 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT REAR SENSOR 
  5. DTC C1232/32 MALFUNCTION IN DECELERATION SENSOR DTC C1234/34 MALFUNCTION IN YAW RATE SENSOR DTC C1243/43 MALFUNCTION IN DECELERATION SENSOR DTC C1244/44 OPEN OR SHORT IN DECELERATION SENSOR CIRCUIT DTC C1245/45 MALFUNCTION IN DECELERATION SENSOR DTC C1381/97 MALFUNCTION IN POWER SUPPLY VOLTAGE YAW/DECELERATION SENSOR 
  6. DTC C1232/32 MALFUNCTION IN DECELERATION SENSOR DTC C1234/34 MALFUNCTION IN YAW RATE SENSOR DTC C1243/43 MALFUNCTION IN DECELERATION SENSOR DTC C1244/44 OPEN OR SHORT IN DECELERATION SENSOR CIRCUIT DTC C1245/45 MALFUNCTION IN DECELERATION SENSOR DTC C1381/97 MALFUNCTION IN POWER SUPPLY VOLTAGE YAW/DECELERATION SENSOR 
  7. DTC C1231/31 MALFUNCTION IN STEERING ANGLE SENSOR CIRCUIT 
SLIP indicator light abnormal
  1. SLIP indicator light circuit
  2. Skid control ECU
 SLIP INDICATOR LIGHT CIRCUIT 
TRAC OFF indicator abnormal If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. TRAC OFF switch circuit
  1. DTC CHECK/CLEAR 
  2. TRAC OFF INDICATOR LIGHT, TRAC OFF SWITCH CIRCUIT 
DTC of VSC check cannot be done If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. Tc terminal circuit
  1. DTC CHECK/CLEAR 
  2. TC TERMINAL CIRCUIT 
VSC warning light abnormal If the symptoms still occur even after the following circuits in suspect areas are inspected and proved to be normal, replace the skid control ECU.
  1. Check the DTC again and make sure that the normal code is output.
  2. VSC warning circuit
  1. DTC CHECK/CLEAR 
  2. VSC WARNING LIGHT CIRCUIT (REMAINS ON) 
scientia non olet · About LEMON Manuals