LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L - Repair Instructions - On Vehicle) >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Flywheel Holding Tool
    GM1825675Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine drive belt. Refer to Drive Belt Replacement (With A/C)  or Drive Belt Replacement (Without A/C) .
  2. Remove the starter motor. Refer to Starter Replacement .
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Install the J 43653  (1) to the engine block, in order to hold the flywheel. See Special Tools .
    5. Fig 2: View Of Crankshaft Balancer, Bolt & Washer
    GM1594330Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft balancer bolt and washer. Discard the bolt.
  6. Remove the balancer using a universal removal tool.
scientia non olet · About LEMON Manuals