Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the parking pawl (3).
- Install the pivot pin (1).
- Install the parking pawl spring (2). The straight end of the spring locates against the case and the hooked end locates over the parking pawl.
- Install the extension housing. Refer to Case Extension and Gasket Replacement .
- Remove the transmission jack.
- Install the transmission fluid pan. Refer to Automatic Transmission Fluid and Filter Replacement .
- Install the propeller shaft. Refer to Propeller Shaft Replacement (Automatic) .
- Fill the transmission to the proper level. Refer to Transmission General Specifications , Fluid Capacity Specifications , and Transmission Fluid Level and Condition Check .
- Lower the vehicle.