LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Output Shaft Flange and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transmission mount. Refer to Transmission Rear Mount Replacement .
    3. Fig 1: View Of Shift Control Linkage & Manual Shift Shaft Nut
    GM1612916Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission manual shift shaft nut (1).
  4. Disconnect the shift linkage (2) from the transmission.
  5. Place the transmission in neutral by rotating the transmission shift shaft clockwise 2 clicks.
  6. Remove the propeller shaft. Refer to Propeller Shaft Replacement (Automatic) .
    7. Fig 2: Identifying Drive Flange Components
    GM1613877Courtesy of GENERAL MOTORS CORP.
  7. Install J-08614-A  to the drive flange.
  8. While holding J-08614-A  , remove the drive flange nut (5) using J 29873  .
  9. Remove J-08614-A  from the drive flange.
  10. Remove the drive flange thrust washer (4).
  11. Remove the drive flange (2) using J 45019  .
  12. Remove the drive flange O-ring seal (3) from the drive flange.
    13. Fig 3: View Of Transmission Case Extension Seal
    GM794669Courtesy of GENERAL MOTORS CORP.
  13. Use J 6125-1B  and J 23129  to remove the transmission case extension seal (1). See Special Tools .
scientia non olet · About LEMON Manuals