Ignition Lock Cylinder Bulb Replacement

Fig 1: Ignition Lock Cylinder Bulb

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
1	Key Hole Lamp Retaining Screw NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb ft)
2	Ignition Key Alarm Switch Assembly Procedure Disconnect the electrical connectors. Twist to release the key hole lamp bulb.

Callout

Component Name

Preliminary Procedure:
Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .

Key Hole Lamp Retaining Screw

NOTE: Refer to Fastener Notice .

Tighten: 2.5 N.m (22 lb ft)

Ignition Key Alarm Switch Assembly

Procedure