LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter, Turbine Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a new torque convertor O-ring seal on the end of the turbine shaft.
    2. Fig 1: View Of Torque Converter Assembly & O-Ring Seal
    GM104552Courtesy of GENERAL MOTORS CORP.
  2. Install the torque convertor onto the transmission.
  3. Install the transmission into the vehicle. Refer to Transmission Replacement .
  4. Adjust the transmission oil level. Refer to Transmission Fluid Checking Procedure .
    IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  5. Reset the TAP values. Refer to Transmission Adaptive Functions  .
scientia non olet · About LEMON Manuals