Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.
- Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.
- Install the oil pan. Replace the bottom pan if damaged.
- Install the oil pan attaching bolts.
Tighten: Tighten the bolts to 14 N.m (124 lb in).
- Lower the vehicle.
- Fill the transmission.
- Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure
- Inspect the oil pan gasket for leaks.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.