LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Intermediate/Fourth Servo Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fig 1: View Of Intermediate/Fourth Servo Assembly & Bolts
GM589165Courtesy of GENERAL MOTORS CORP.
  1. Install the intermediate/4th band servo piston spring, the servo and the servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  2. Install the filter and the pan. Refer to Automatic Transmission Fluid Filter and Seal Replacement  .
  3. Lower the vehicle.
  4. Fill the transmission with DEXRON® VI fluid.
  5. Inspect the transmission oil level. Refer to Transmission Fluid Checking Procedure .
    IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  6. Reset the TAP values. Refer to Transmission Adaptive Functions  .
scientia non olet · About LEMON Manuals