Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Transmission Mount & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the mount to the transmission.
Tighten: Tighten the transmission mount to transmission bolts to 50 N.m (37 lb ft).

Fig 2: View Of Front Transaxle Mount Through Bolt

Courtesy of GENERAL MOTORS CORP.

Install the transmission mount through bolt.
Tighten: Tighten the bolt to 110 N.m (81 lb ft).
Lower the vehicle.
Perform the powertrain mount balance procedure. Refer to Powertrain Mount Balance Procedure - Lower Mount in Engine Mechanical 2.2L (L61).