LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance Procedure - Lower Mount

Powertrain Mount Balance Procedure - Lower Mount

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  2. Loosen the front mount through bolt. Do not remove.
    3. Fig 2: View Of Transaxle Mount And Mounting Bolts
    GM928736Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear mount through bolt. Do not remove.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the rear motor mount through bolt.

    Tighten:  Tighten the bolt to 110 N.m (81 lb ft).

    6. Fig 3: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front motor mount through bolt.

    Tighten:  Tighten the bolt to 110 N.m (81 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals