LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 2.2L (L61) - Troubleshooting & Diagnosis) >> Fuel Injector Diagnosis (w/J39021 or w/Tech 2) >> Component Testing >> Fuel Injector Balance Test with Special Tool

Fuel Injector Balance Test with Special Tool

WARNING: This page is about a different variant/trim than selected.
  1. Set the selector switch on the fuel injector tester to the Balance Test 50 pulses/10 ms position.
  2. Connect the SA9182E to a fuel injector with a J 44602 .
  3. Command the fuel pump relay ON and then OFF three times with a scan tool. On the last command, as the fuel pressure begins to slowly degrade and stabilize, select a fuel pressure within 34 kPa (5 psi) of the maximum pump pressure. Record this fuel pressure. This is the starting pressure at which you will pulse each injector.
  4. Command the fuel pump relay ON one more time and energize the fuel injector by depressing the Activate Injector button on the SA9182E at the previously selected pressure.
  5. After the injector stops pulsing, select Min from the Display Mode and record the Min pressure.
    IMPORTANT: New test results will not be recorded if the Min/Max results are not cleared after each injector is tested.
  6. Clear the Min/Max results.
  7. Select Normal from the Display Mode.
  8. Repeat steps 2 and 4 through 7 for each fuel injector.
  9. Perform the Pressure Drop Calculation.
scientia non olet · About LEMON Manuals