LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Belt Tensioner Bolt
    GM894941Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the tensioner assembly and bolt, if removed.

    Tighten:  Tighten the drive belt tensioner bolt 45 N.m (33 lb ft).

  2. Route the belt around the alternator and the A/C compressor.
    3. Fig 2: View Of Drive Belt Tensioner Tool
    GM951829Courtesy of GENERAL MOTORS CORP.
  3. Install the J 44811  onto the tensioner and unload spring tension from the tensioner while positioning the belt. See Special Tools .
  4. Release the tensioner and remove the tool.
  5. Install the right engine inner splash shield.
  6. Install the right wheel and hand tighten the wheel nuts.
  7. Lower the vehicle.

    Tighten:  Tighten the wheel nuts 125 N.m (92 lb ft).

  8. Connect the negative battery cable

    Tighten:  Tighten the battery terminal bolt 17 N.m (23 lb ft).

scientia non olet · About LEMON Manuals