LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Tensioner Tool
    GM951829Courtesy of GENERAL MOTORS CORP.
    CAUTION: The tensioner assembly's internal parts are not serviceable. To avoid injury, do not disassemble the tensioner.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise the vehicle on the hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right wheel and the splash shield.
  4. Install the J 44811  onto the tensioner. See Special Tools .
  5. Remove the accessory drive belt.
    6. Fig 2: Removing & Installing Belt Tensioner Bolt
    GM894941Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To remove the tensioner bolt an access hole has been provided through the inner and outer engine rail.
  6. Remove the tensioner assembly.
  7. Remove the tensioner bolt.
scientia non olet · About LEMON Manuals