LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 35268-A  Camshaft/Front Main Seal Installer. See Special Tools .

    Fig 1: Removing Crankshaft Front Oil Seal
    GM896336Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft balancer pulley.
  2. Using a seal removal tool or screwdriver, remove the oil seal from the front cover.
    • Clean the seal bore and oil drain back passage way.
    • Ensure that the oil drain back passage is free of RTV or debris.
    3. Fig 2: Installing Crankshaft Front Oil Seal
    GM895045Courtesy of GENERAL MOTORS CORP.
  3. Install a new oil seal using the J 35268-A  . See Special Tools .
      IMPORTANT: Always ensure that the oil pump cover is properly supported when installing.
    • Ensure that the font main oil seal is fully and evenly sealed.
    • Apply a thin film of oil to seal the lip.
  4. Install the crankshaft balancer pulley. Refer to Crankshaft Balancer Replacement .
scientia non olet · About LEMON Manuals