LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
    Fig 1: Depressing Tensioner Arm
    GM896375Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise the vehicle on a hoist.
  3. Remove the right wheel and splash shield.
  4. Install the J 44811  . See Special Tools .
  5. Remove the accessory drive belt.
    6. Fig 2: Removing & Installing Harmonic Balancer Using Holder On Damper Assembly
    GM895194Courtesy of GENERAL MOTORS CORP.
  6. Install the J 38122-A  .
    7. NOTE: The crankshaft damper pulley bolt head and the washer assembly prevents oil leakage at the center of the pulley. Do not damage the sealing surfaces. If the pulley can not be removed by pulling with your hand, use a three-jaw puller.
    NOTE: To avoid damage to the front cover assembly, do not pry against the cover.
    Fig 3: Removing & Installing Damper Assembly
    GM895197Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft balancer pulley bolt and pulley. Discard the pulley bolt.
scientia non olet · About LEMON Manuals