LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Prelubing >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 45299  Engine Preluber. See Special Tools .

    Fig 1: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.
  1. Locate the oil pressure switch and remove.
  2. Install the M12 x 1.75 adapter P/N 509376.
    3. Fig 2: Identifying Engine Preluber J 45299
    GM863255Courtesy of GENERAL MOTORS CORP.
  3. Install the flexible hose to the adapter and open the valve.
  4. Pump the handle on the J 45299  in order to flow a minimum of 1-1. See Special Tools .9 liters (1-2 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
  5. Close the valve and remove the flexible hose and adapter from the engine.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the oil pressure switch to the engine.

    Tighten:  Tighten the oil pressure switch to 22 N.m (16 lb ft).

  7. Top-off the engine oil to the proper level.
scientia non olet · About LEMON Manuals