Engine Flywheel Installation
WARNING: This page is about a different variant/trim than selected.
Tools Required
- J 38122-A Crankshaft Balancer Holder. See Special Tools .
- J 45059 Angle Meter. See Special Tools .
- Install the flywheel.
- Install the NEW bolts.
- Holding the crankshaft balancer with the J 38122-A
, tighten the bolts evenly. See Special Tools .
Tighten: Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059 . See Special Tools .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.