Cylinder Head Assemble

Tools Required

• J 8062  Valve Spring Compressor. See Special Tools .
• J 9666  Valve Spring Tester
• J 43963  Valve Spring Compressor Adapter. See Special Tools .

Fig 1: View Of Cylinder Head Plugs
Courtesy of GENERAL MOTORS CORP.
NOTE: In order to avoid damage, install the spark plugs after the cylinder head has been installed on the engine.
1. Install NEW cylinder head plugs. Coat the plugs with sealer GM P/N 12345382 (Canadian P/N 10953489), or equivalent.
2. Inspect the valve springs for the following conditions:
   • Expanded height
   • Unparallel spring ends
   • Spring tension using J 9666
   • Any distorted springs should be replaced
Fig 2: Applying Prussian Blue
Courtesy of GENERAL MOTORS CORP.
3. Assemble the valves.
4. Use the following steps to measure valve runout:
   1. Apply a dab of Prussian blue on the entire valve face. Seat the valve but do not rotate it. The Prussian blue traces transferred to the valve seat are an indication of concentricity of the valve seat.
   2. Clean all traces of Prussian blue.
   3. Apply a dab of Prussian blue on the valve seat and repeat the check. The traces of Prussian blue transferred to the valve face indicates valve face concentricity.
Fig 3: Identifying Engine Valves
Courtesy of GENERAL MOTORS CORP.
Fig 4: Identifying Valve Seals
Courtesy of GENERAL MOTORS CORP.
5. Replace the valves, if required.
6. Install the new valve seals.Fully seat the seals on the valve guides.
   Fig 5: View Of Valve Springs

   Courtesy of GENERAL MOTORS CORP.
7. Install the spring.
   Fig 6: Identifying Valve Spring Retainers

   Courtesy of GENERAL MOTORS CORP.
8. Install the retainer.
9. Using theJ 8062  and the J 43963  , compress the valve spring. See Special Tools .
10. Install the valve keys.
11. Slowly release the J 8062  and the J 43963  from the valve/spring assembly. See Special Tools .
12. Inspect for proper valve key seating.
13. Install the remaining valves, springs, and other components.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 7: Identifying Cylinder Head Air Bleed Tube

    Courtesy of GENERAL MOTORS CORP.
14. Install the cylinder head air bleed tube.

Tighten:  Tighten the bolts to 15 N.m (11 lb ft).