Wiring Harness Removal

WARNING: This page is about a different variant/trim than selected.

Tools Required

J 41101 Pass-Through Connector Remover. See Special Tools .

Fig 1: View Of Transmission Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Push the J 41101 or equivalent onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs. See Special Tools .
With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
Remove the wiring harness (11).