Reverse Input and Second Roller Clutch Assemble

Tools Required

• J 23327  Clutch Spring Compressor
• J 41232  Return Spring Compressor. See Special Tools .
• J 41233  Inner Seal Installer. See Special Tools .

Fig 1: Using J 41233 To Install Reverse Clutch Inner Seal Assembly
Courtesy of GENERAL MOTORS CORP.
1. If the reverse clutch inner seal assembly (456) was damaged and removed, install a new reverse clutch inner seal assembly (456). Use the J 41233  . See Special Tools .
2. Assemble the reverse clutch piston and seal assembly (456). In order to aid in the assembly, lubricate the seal with transmission fluid.
3. Assemble the reverse clutch return spring and retainer assembly (458) with the smaller outside diameter down.
Fig 2: Locating Return Spring Snap Ring
Courtesy of GENERAL MOTORS CORP.
4. Compress the reverse clutch return spring. Use the J 41232  and J 23327  . See Special Tools .
5. Assemble the return spring snap ring (459).
6. Remove the J 41232  and J 23327  . See Special Tools .
Fig 3: Identifying Reverse Clutch Plates
Courtesy of GENERAL MOTORS CORP.
7. Assemble the wave plate (460).
8. Assemble the 3 steel plates (461) and the 3 new fiber plates (462) in alternating order beginning with a steel plate (461).
9. Assemble the reverse clutch backing plate with the beveled edge up.
10. Assemble the snap ring in the reverse clutch housing in order to retain the reverse clutch plates.