LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  2. Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Left Side  and Engine Mount Strut Replacement - Right Side .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the catalytic converter from the engine exhaust manifold. Refer to Catalytic Converter Replacement .
  5. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  6. Remove the right engine splash shield. Refer to Engine Splash Shield Replacement .
    7. Fig 1: Identifying Engine Mount Lower Nuts
    GM96002Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine mount lower nuts.
    8. NOTE: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.
  8. Use a utility stand and a block of wood in order to raise the engine.
    9. Fig 2: Engine Mount Bracket To Oil Pan Bolts
    GM96007Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bracket-to-oil pan bolts.
  10. Remove the engine mount and the engine mount bracket.
    11. Fig 3: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine mount from the engine mount bracket.
scientia non olet · About LEMON Manuals