LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the engine mount bracket.
    2. Fig 2: Engine Mount Bracket To Oil Pan Bolts
    GM96007Courtesy of GENERAL MOTORS CORP.
  2. Install the engine mount bracket with the engine mount to the oil pan.
    3. NOTE: Refer to Fastener Notice .
  3. Install the engine mount bracket-to-oil pan bolts.

    Tighten:  Tighten the bolts to 58 N.m (43 lb ft).

  4. Use the utility stand in order to lower the engine.
    5. Fig 3: Identifying Engine Mount Lower Nuts
    GM96002Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount lower nuts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

  6. Install the right engine splash shield. Refer to Engine Splash Shield Replacement .
  7. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  8. Connect the catalytic converter pipe to the engine exhaust manifold. Refer to Catalytic Converter Replacement .
  9. Lower the vehicle.
  10. Install the engine mount struts. Refer to Engine Mount Strut Replacement - Left Side  and Engine Mount Strut Replacement - Right Side .
  11. Install the throttle body air inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
scientia non olet · About LEMON Manuals