LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Apply sealant to the keyway of the balancer. Refer to Sealers, Adhesives, and Lubricants  for the 3.5L engine.
    2. Fig 1: Installing J 29113 Onto Crankshaft
    GM909647Courtesy of GENERAL MOTORS CORP.
  2. Install the crankshaft balancer. Use the J 29113  . See Special Tools .
  3. Remove the J 29113  . See Special Tools .
  4. Install the J 43442  to the flywheel to prevent flywheel rotation. See Special Tools .
    5. Fig 2: Removing/Installing Crankshaft Balancer Bolt And Washer
    GM909519Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the crankshaft balancer washer and the bolt.

    Tighten:  Tighten the bolt to 160 N.m (118 lb ft).

  6. Remove the J 43442  from the flywheel. See Special Tools .
  7. Install the torque converter cover. Refer to Torque Converter Cover Replacement for the 4T65-E Automatic Transaxle.
  8. Raise the frame to the original position.
  9. Install and tighten the frame bolts. Refer to Front Frame Replacement .
  10. Install the right engine splash shield. Refer to Engine Splash Shield Replacement .
  11. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  12. Lower the vehicle.
  13. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals