Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: Identifying Front Inflatable Restraint Passenger Presence System

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. CAUTION: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction. NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove the front bucket seat. Refer to Front Seat Replacement - Bucket . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing .
1	Handle, Seat Recliner Refer to Driver Seat Recliner Handle and Passenger Seat Recliner Handle Replacement .
2	Plug, Seat Recliner Handle
3	Cover, Seat Outer Adjuster Refer to Front Seat Adjuster Track Finish Cover Replacement .
4	Cover, Seat Outer Adjuster Refer to Front Seat Adjuster Track Finish Cover Replacement .
5	Seat Back Assembly Refer to Front Seat Back Replacement .
6	Cover, Seat Cushion Refer to Front Seat Cushion Cover and Pad Replacement .
7	Pad Assembly, Seat Cushion Refer to Front Seat Cushion Cover and Pad Replacement .
8	Frame Assembly, Seat Cushion
9	Retainers, Inflatable Restraint Passenger Presence System Bladder (Qty: 2)
10	Bladder, Inflatable Restraint Passenger Presence System
11	Screws, Electronic Control Unit (Qty: 2) Tighten: 2 N.m (18 lb in)
12	Electronic Control Unit
13	Switch, Inflatable Restraint Passenger Presence System Pressure Refer to Control Module References for programming and setup information. Tip: Remove the sensor assembly wiring harness attachments from the seat cushion frame. Note the location of the wire routing.