Thread Repairs For Threaded Bushes With Collar

Information 

• The repair bush must be installed recessed. Use the tool from the tool set for milling the relevant shoulder.

Information 

Information 

• While pressing in the base thread, a noticeably larger amount of force on the screw-in tool is required to form the internal thread. Pr essing is finished when the screw-in tool can be turned further more easily. 

Information 

• Remove wire thread inserts (Helicoil) that are installed as standard before drilling out. 

1. Drill out the old thread fully using a drill bit (contained in the set) -B-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Thread

2. Mill in shoulder using countersink tool -C-  .
   Fig 1: Checking Shoulder Dimension

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Shoulder

3. Cut thread.
   1. 3.1  Cut thread to dimension -Y-  using a cutting tool.
   2. 3.2  Clean the thread.
      1. 3.2.1  Blow drill chips out of the thread with compressed air.
      2. 3.2.2  Clean thread with brake cleaner.
      3. 3.2.3  Dry thread by blowing it with compressed air.
   Fig 2: Checking Thread Cutting Dimension

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Thread

4. Position threaded bush on screw-in tool.
   1. 4.1  Clean thread on bush and on screw-in tool.
   2. 4.2  Oil the screw-in tool -E-  .
   3. 4.3  Screw threaded bush -A-  onto the screw-in tool -E-  by hand.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Threaded bush on screw-in tool

5. Screw in threaded bush -A-  fully using the screw-in tool -E-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Threaded bush

6. Form and press the threaded bush by turning further with the screw-in tool -E-  in the base thread.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Threaded bush

7. Unscrew and remove screw-in tool -E-  from threaded bush.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Screw-in tool