Setting Flow-Form Welding Rivets

Information 

Adjust projection of stud holder -1-  according to material thickness of the aluminum component using flow-form welding rivets:

Fig 1: Checking Stud Holder Adjusting Projection Dimension

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Projection

• -A-  : Standard projection

  >5X00IN11 STUD WELDING 

• -B-  : Additional projection due to material thickness of aluminum spare part -2- 

Information 

Adjust pressure setting on > VAS 6790 - Compact Booster  to pressure stage 4.

Information 

Unless specified otherwise in the specific Workshop Service Information, the loosened friction element welded joints will be replaced with flow-form welding rivets. The components will also be bonded at the joint.

Information 

heck the following before welding:

• The coating on flow-form welding rivets must not be damaged. 
• Flow-form welding rivets must not touch aluminum spare parts because this can result in a shunt during welding. 

1. Drill through aluminum spare part at the position specified in the Workshop Service Information using a drill bit with a diameter of 7.0 mm.
2. Set up stud welder and prepare components for welding.

   >5X00IN11 STUD WELDING 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Preparing stud welder

   1. 2.1  Fit stud holder -1-  > VAS 852 001/5 - Rivet holder  for flow-form welding rivets.
   2. 2.2  Fit open gas nozzle -2-  .

   WELDING PARAMETER GUIDELINES FOR FLOW-FORM WELDING RIVETS 

   Bolt	Welding time [ms)	Amperage rating [A)	Lift [mm)	Gas pre-flow time [ms)	Gas parameters [l/min)	Power terminal	Ground terminal	Polarity
   Flow-form welding rivets	7	910	1.0	1, 500	6-8	Gun	Component	Normal

3. Position and secure aluminum spare part -1-  on steel component.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Positioning and securing aluminum component

4. Push flow-form welding rivets -1-  onto stud holder -2-  > VAS 852 001/5 - Rivet holder  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Flow-form welding rivet

5. Weld flow-form welding rivets onto the steel component through the drilled hole in the aluminum spare part.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Welding

6. After welding all flow-form welding rivets, remove aluminum spare part from the steel component.
7. Prepare steel and aluminum components for bonding and riveting and coat with adhesive.

   >5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00 

8. Position and secure aluminum spare part on steel component.
9. Set and press flow-form welding rivets using > VAS 6790 - compact booster  and punch and bottom die pair -1-  from > VAS 6790/70 - rivet inserts  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Setting flow-form welding rivets