Installing Wing Fastening Rail

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Apply adhesive evenly over the entire bonding surface.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install wing rail and check that it fits perfectly.
Apply adhesive on joint areas of the body. > Application depth 0.5 mm
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Wing rail
Apply adhesive on joint areas of the body. > Application depth 0.5 mm
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing A-pillar
1. 3.1 Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm
Screw in self-tapping screws
>5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Self-tapping screws