Preparing Rear Cross Member For Installation
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Fit in rear cross member and secure it to the body.
- Drill bore holes > Bore holes
for rivets through both sheet-metal panels. > Diameter 6.6 mm
Bore holes
- Remove rear cross member.
- Prepare marked areas > Bonding areas
for bonding and riveting.
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE
Bonding areas