Preparing End Plates Of Rear Cross Member For Installation
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Fit in end plates for rear cross member and secure them to the body.
- Drill bore holes > Bore holes
for rivets through both sheet-metal panels. > Diameter 6.6 mm
Bore holes
- Remove end plates for rear cross member.
- Prepare marked areas > Bonding and rivet areas
for bonding and riveting.
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE
Bonding and rivet areas