Installing Rear Cross Member

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install rear cross member and check that it fits perfectly.
Apply adhesive on the joint area > Bonding areas of the body.
Apply adhesive evenly over the entire bonding surface > Bonding areas . > Application depth 0.5 mm

>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas
Apply adhesive on the rear cross member > Bonding areas . > Application depth 0.5 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas
1. 3.1 Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm
Set blind rivets > Blind rivets . > BLIND RIVETS 999.190.229.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Blind rivets