Installing End Plates For Rear Cross Member

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Install end plates for rear cross member and check that they fit perfectly.
Apply adhesive on joint areas > Bonding and rivet areas of the body.
Apply adhesive evenly over the entire bonding surface > Bonding and rivet areas .

> Application depth 0.5 mm

>*** 5X00IN21 Working wth body structural adhesive

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding and rivet areas
Apply adhesive on end plate for rear cross member > Bonding and rivet areas.
Apply adhesive evenly over the entire bonding surface > Bonding and rivet areas.

> Application depth 0.5 mm

>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding and rivet areas
1. 3.1 Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm
Set blind rivets > Blind rivets.
Areas -A- : > BLIND RIVETS 999.190.229.01

Areas -B- : > BLIND RIVETS 999.190.227.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Blind rivets
Set blind rivets > Blind rivets . > BLIND RIVETS 999.190.227.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Blind rivets
Screw in self-tapping screws -1- .
>5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Self-tapping screws