Preparing Inner Rear Wheel Housing For Installation

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install inner rear wheel housing and secure it to the body.
Drill bore holes > Bore holes in rivet area for rivets through the inner rear wheel housing. > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes in rivet area
Drill bore holes > Bore holes in rivet area for rivets through the inner rear wheel housing. > Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes in rivet area
Drill bore holes for rivet in area -A- .
> Diameter 6.6 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore
Remove inner rear wheel housing.
Prepare marked areas > Bonding areas for bonding and riveting.
>5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas