Installing Closing Panel

Information 

• Apply adhesive evenly over the entire bonding surface. 
• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Install closing panel and check that it fits perfectly.
2. Apply adhesive on joint areas > Joint areas  of the body. > Application depth 0.5 mm 

   Use body structural adhesive.

   >5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Joint areas

3. Apply adhesive in the marked areas > Bonding areas  on the closing panel. > Application depth 0.5 mm 

   Use body structural adhesive.

   >5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

   1. 3.1  Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 
4. Rivet in closing panel in areas -A, B, C and D-  .

   Areas -A-  : > BLIND RIVFT 999.190.229.01 

   Area -B-  : > BLIND RIVFT 999.190.227.01 

   Area -C-  : > BLIND RIVFT 999.190.230.01 

   Areas -D-  : > FLOW-FORM RIVFT 9A7.003.606.00 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Rivet areas