Subsequent Work
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Install outer side member (rear section).
- Install rear side section.
>*** 535555 Replacing rear side section
Subsequent work for body repairs (with straightening system)
- Release and remove vehicle from the straightening system.
- Clean joint areas and sheetmetal flanges with a wire brush.
- Prime joint areas and sheetmetal flanges with 2K primer.
- Restore standard seal using body sealant.
>*** 5X00IN42 Seam seals
Also seal the repair area carefully.
- Paint repair area and adjacent surfaces, if necessary.
- Restore standard underbody protection using underbody sealant.
- Apply standard cavity preservation.
Also carefully apply cavity preservation to the repair area.
- Install removed accessories in the repair area.